If Using 8 Plotter or Printer
1. Ensure that the plotter or printer is set up correctly:
power is on
n
pens and paper loaded
n
pinch wheels are down
n
some plotters need to have Pl and P2 positions set
n
Press @GE) and then
are functional in the analyzer. Continue with 'Troubleshooting Systems
with Multiple Peripherals, w "Troubleshooting Systems with Controllers," or
the "Step 4. bulty Group Isolation" section in this chapter.
If the result is not a copy of the analyzer display, refer to Chapter 6,
q
"Digital Control Troubleshooting. n
If Using an External Disk Drive
3.
Ensure that the disk drive is set up correctly:
power is on
n
correct disk unit number and volume number (press (j) to access the
n
with hard disk (Winchester) drives, make sure the configuration switch is
n
properly set (see drive manual)
or
dress is set correctly. Press @CGZiI)
.