Step3.Hp.ibsystemscheck - Agilent Technologies HP 8719D Service Manual

Step 3. HP-IB Systems Check
Check the analyzer's HP43 functions with a ICWWT& work&g passive peripheral
(such as a plotter, printer, or disk drive).
1. Connect the peripheral to the analyzer using a &own
peripheral.
device addresses will be recognized by the analyzer. The factory default
addresses are:
Note
n
Peripheral addresses are often set with a rear panel switch.
Refer to the manual of the peripheral to read or change its
address
and the appropriate softkeys to verify that the
I
HP 8719Di20D122D
Plotter port
Controller
Power meter
The address set on each device must match the one
recognized by the analyzer (and displayed).
good
to enable the analyzer to control the
HP-IB Addrem
5
1
0
21
13
HP-IB cable.