The following verification procedure is automated by the analyzer firmware For
each veriikation device, the analyzer reads a Gle from the verifkation disk and
sequentially measures the magnitude and phase for all four S-parameters
The device number and test number for each verification device are as follows:
1
2
3
4
Press (G)
35.
In the active entry area on the display, the following will be displayed:
36.
TEST 27 Ver Dev 1
If the record function was switched on in step 5, or if a printout is not
37.
desired, go to step 38.
Make sure the paper in the printer is set up so that printing starts at the top
of the page.
38.
Press
to create page breaks in appropriate places
Connecting a Device
39. When prompted, insert the 20 dB attenuator as shown in the following
27
28
29
30
sired, p
20 dB attenuatoT
.