T-S TORX screwdriver
n
n
n
small slot screwdriver
n
ESD (electrostatic discharge) grounding wrist strap
n
Required Diskette
3.5" diskette, 1.44 MB, formatted (DOS)
n
Removal
1. Disconnect the power cord and remove the top, bottom, and left side covers
(refer to "Covers" in this chapter).
2. Remove the front panel (refer to "Front Panel Assembly" in this chapter).
3. Turn the instrument upside-down and disconnect the ribbon cable (item 1)
from the disk drive.
4. Remove the four screws (item 2) that secure the disk drive to the disk drive
bracket. There are two screws on the top, and two screws on the bottom.
5.
Slide the disk drive out of the analyzer, and set the disk drive aside..
6. Remove the four screws (item 3) that secure the disk drive bracket to the
side of the analyzer, and remove the bracket.
Note
Save the screws removed in this step for use later when
installing the new disk drive bracket.
Assembly Replacement and Post-Repair Procedures