Agilent Technologies HP 8719D Service Manual page 187

Make a list of these assemblies
n
Delete the following assemblies from your list as they have already been
n
verified earlier in this section.
All phase lock
4. Switch off the analyzer.
5.
Of those assemblies that are left on the list, remove or disconnect them
from the analyzer one at a time. Qble 5-4 shows the best order in which to
remove them, sorting them from most to least accessible. Table 5-4 also lists
any associated assemblies that are supplied by the assembly that is
removed. After each assembly is removed or disconnected, switch on the
analyzer and observe the LEDs
Note
n
n
n
If all the LEDs light, the assembly removed (or one receiving power from it) is
q
faulty.
If the LEDs are still not on steadily, continue to "Inspect the Motherboard."
q
Always switch of the analyzer bqtim renwuing or
When extensive disassembly is required, refer to Chapter 14,
"Assembly Replacement and Post-Repair Procedures n
Refer to Chapter 13, "Replaceable Parts," to identify specific
cables and assemblies that are not shown in this chapter.
being