Agilent Technologies HP 8719D Service Manual page 475

self diagnose softkey, 10-9
self-test, 4-3
SELF TEST #%I FAILED, lo-53
sequence check for power up , 4-12
serial number correction constants
adjustment, 3-15
service and support options, l-8
service center procedure, 4-2
Service Equipment and Analyzer
Options, l-l
service features, lo-22
service key menus, 10-l
service features, lo-22
service key mnemonics, 10-l
service mnemonic definitions, 10-38
SERVICE MODES, lo-23
service modes more menu, lo-25
service test equipment, l-l
service tools list, l-l
servicing the analyzer, 4-2
setup
fractional-N spur avoidance and
FM sideband adjustment, 3-50
frequency accuracy adjustment,
3-46
intensity check, 6-15
source power check, 4-17
setup check for disk drive, 4-8
setup check for plotter or printer,
4-8
short and open device verification,
9-5
shutdown circuit
post regulator, 12-6
shutdown circuit on A8, 12-6
shutdown circuitry disable, 5-16
softkeys, 10-l
Source Block, 12-17
source check, 4-16
Source Group Theory, 12-12
source match (ESF and ESR), 11-10
SOURCE POWER TURNED OFF,
RESET UNDER POWER MENU,
10-53
Source Pretune, 12-14
source pretune correction constants
adjustment, 3-10
Source Troubleshooting, 7- 1
Source Troubleshooting Flowchart,
7-2
SOURCE TUNE OFF, lo-23
speed
fan, 5-20
spur avoidance and FM sideband
adjustment, 3-49
SRAM RAM, lo-12
SRC ADJUST MENU, lo-23
Start Troubleshooting chapter, 4-l
status terms for test, 10-5
STORE EEPR ON OFF, lo-26
stuck key identification, 6-22
support and service options, l-8
Swap Samplers to Check A64 R
Sampler, 7-7
SWEEP MODE CHANGED TO CW
TIME SWEEP, lo-53
Sweep Trig., lo-14
Switch Repeatability, 4-2 1
symbol conventions, lo-38
System Operation, 12-1
system performance uncorrected,
11-6
system verification
post-repair, 3-3, 14-40
System Verification, 2-15
system verification tests, 10-4, lo-16
Sys Ver Init., lo-16
SYS VER TESTS, 10-5