Agilent Technologies HP 8719D Service Manual page 318

Error 'I&m Inspection
Note
If the correction is not active, press (GJ
1.
The analyzer copies the first calibration measurement trace for the selected
error term into memory and then displays it. 'Ihble 11-l lists the test
numbers.
Press &ZTZRef) and adjust the scale and reference to study the error term
trace.
Press @X&ZTFctn) and use the marker functions to determine the error term
magnitude.
Compare the displayed measurement trace to the trace shown in the
following "Error Term descriptions" section, and to previously measured
data. If data is not available from previous measurements, refer to the
typical uncorrected performance specifications listed in 'Ihble 11-2 and
Make a hardcopy of the measurement results:
a. Connect a printing or plotting peripheral to the analyzer.
appropriate peripheral to verify that the HP-IB address is set correctly on
the analyzer.
identify it later.
Note
For detailed information on creating hardcopies, refer to
"Printing, Plotting, and Saving Measurement Results" in the
6. Repeat steps 1 through 5 for each test number that corresponds to a
calibration coefficient (see 'Ihble 1l-l).
choose
either -PRWI' or P&gT .
HP
Error Terms 1 l-5