Changing Main Fuse; Changing The Fuses Of Individual Power-Consuming Components - KTM 525 XC ATV 2008 Owner's Manual

MAINTENANCE ON CHASSIS AND ENGINE

changing main fuse

Changing the fuses of individual power-consuming components

Connect the battery charger to the battery. Switch on the battery charger.
Battery charger (58429074000)
You can also use the battery charger to test rest potential and start potential of the
battery, and to test the generator. With this device, you cannot overcharge the bat-
tery.
Info
Never remove the lid
Charge the battery according to the instructions
Switch off the charger after charging. Disconnect the battery.
Specification
The charge current, charge voltage and charge time must not be exceeded.
Charge the battery regularly when the
vehicle is not in use.
Install the rear fender. (
100087-10
Switch off all power-consuming components and switch off the engine.
The main fuse
Remove protection covers
Remove the faulty main fuse.
Info
You can recognize a blown fuse by its broken filament
Warning
Fire hazard The electrical system can be overloaded by the use of incorrect
fuses.
Use only fuses with the prescribed amperage. Never by-pass or repair
fuses.
Insert a new fuse.
Fuse (58011109120)
Info
If the new fuse burns out, contact an authorized KTM workshop.
100091-10
Tip
The spare fuse
available if needed.
Replace the protection covers.
Remove the front cover. (
Switch off all power-consuming components and switch off the engine.
.
3 months
P. 64)
is located in the starter relay
.
should always be present in the starter relay so that it is
P. 62)
on the battery casing.
in front of the battery.
.
59