11/WIRING HARNESS, BATTERY
Ignition curve plug connection
15.1
Changing the ignition curve
15.2
–
Remove the front trim. (
Changing the ignition curve from Performance to Soft.
–
Disconnect plug-in connector
Soft – The plug-in connector is disconnected for better driveability. (
Changing the ignition curve from Soft to Performance.
–
Connect the plug-in connector
Performance – The plug-in connector is connected to achieve better performance. (
–
Install the front trim. (
Removing the battery
15.3
Warning
Risk of injury Battery acid and battery gases cause serious cauterization.
–
Keep batteries out of the reach of children.
–
Wear suitable protective clothing and goggles.
–
Avoid contact with battery acid and battery gases.
–
Keep the battery away from sparks or open fire. Charge only in well ventilated rooms.
–
In the event of skin contact, rinse with large amounts of water. If battery acid gets in the eyes, rinse with water for at least
15 minutes and contact a doctor.
Installing the battery
15.4
Plug-in connector
Possible states
Performance – The plug-in connector is connected to achieve better performance.
•
Soft – The plug-in connector is disconnected for better driveability.
•
301829-10
p. 69)
. (Figure 301829-10
. (Figure 301829-10
p. 70)
–
Switch off all power consumers and switch off the engine.
–
Remove the rear fender. (
–
Disconnect the negative (minus) cable
–
Pull back the plus pole cover and disconnect the positive (plus) cable
tery.
–
Loosen the rubber band
–
Remove the battery.
300279-10
–
Place the battery in the battery holder.
Battery (YTX5L-BS) (
–
Reconnect rubber band
–
Attach the positive (plus) cable and replace the plus pole cover
–
Connect the negative (minus) cable
–
Install the rear fender. (
300279-11
is located under the trim at the front on the frame tube.
p. 83)
p. 83)
p. 83)
p. 70)
.
p. 210)
.
of the battery.
p. 71)
p. 83)
of the battery.
.
83
of the bat-