10/REAR WHEEL
Adjusting the toe width of rear axle
14.7
Warning
Danger of accidents Modifications to the suspension settings can seriously alter the vehicle's ride behavior.
–
Following modifications, ride slowly at first to get the feel of the new ride behavior.
2
0 1
0 0 3
0
2
–
Loosen the screws
Alternative 1
–
Insert the tool
element.
Alternative 2
–
Position the special tool at the rear wheel eccentric element.
Hook wrench (83019011000) (
–
To adjust the chain tension
rotate the rear wheel eccentric element forward or backward.
Guideline
Chain tension
Info
Rotating the rear wheel eccentric element forward increases chain tension.
Rotating the rear wheel eccentric element backward reduces chain tension.
The rear wheel eccentric element should always be positioned such that the
grease nipple
ground clearance.
301797-10
–
Fully tighten screws
Guideline
Screw, rear wheel eccentric element
–
Remove the tool
–
Engage 1st gear.
–
Loosen nuts
–
Jack up the vehicle. (
–
Remove the nuts
301538-10
Setting a narrow toe width:
–
Mount the wheel hub
–
Mount the conical ring
–
Mount the spacer
–
Mount the washer and the new self-locking nut.
100103-10
by four turns.
from the tool set into the hole
p. 234)
, slowly turn at the rear wheel or the special tool to
is visible. This ensures that the vehicle has the greatest
.
.
of the wheel hubs on both sides.
p. 12)
on both sides and take all parts off of the rear axle.
.
with the cone facing outward.
with the cone facing inward.
of the rear wheel eccentric
140... 145 mm (5.51... 5.71 in)
M8
20 Nm
(14.8 lbf ft)
77