04/SHOCK ABSORBER, SWINGARM
Installing the rear shock absorber
8.26
Rear shock absorber - changing the oil
8.27
Danger
Danger of accidents Disassembly of pressurized parts can lead to injury.
–
The shock absorber is filled with high density nitrogen. Adhere to the description provided.
–
Position the shock absorber in the vehicle with the reservoir on the right. Mount
and tighten the top screw
Guideline
Screw, rear top shock absorber
–
Position the shock absorber in the swingarm. Mount and tighten the bottom screw.
Guideline
Screw, rear bottom shock absorber
–
Remove the tension belt.
–
Install the rear fender. (
–
Remove the vehicle from the work stand. (
301834-10
Condition
The shock absorber has been removed.
–
Remove the spring from the rear shock absorber. (
–
Note down the present state of rebound damping
–
Completely open the adjusters of the rebound and compression damping.
201050-11
–
Remove rubber cap
–
Slowly open screw
The pressurized nitrogen is bled off.
201051-10
–
Remove screw
–
Bleed and fill the damper of the rear shock absorber. (
–
Fill the damper of the rear shock absorber with nitrogen. (
201052-10
.
M12
M12
p. 71)
of the reservoir.
.
. Let the oil drain out.
60 Nm
(44.3 lbf ft)
70 Nm
(51.6 lbf ft)
p. 12)
p. 44)
and compression damping
p. 54)
p. 56)
42
.