Removing The Crankshaft Seal Ring In The Clutch Cover; Installing The Crankshaft Seal Ring In The Clutch Cover; Removing The Oil Pressure Regulator Valve; Checking Spring Length Of Oil Pressure Regulator Valve - KTM 450 SX ATV 2010 Repair Manual

30/ENGINE - WORK ON INDIVIDUAL PARTS

Removing the crankshaft seal ring in the clutch cover

19.6

Installing the crankshaft seal ring in the clutch cover

19.7

Removing the oil pressure regulator valve

19.8

Checking spring length of oil pressure regulator valve

19.9
–
Remove shaft seal ring
301678-10
–
Press in shaft seal ring
Info
Support the clutch cover properly when pressing in.
–
Grease the sealing lip.
Long-life grease (
301678-10
–
Blow out the oil channel with compressed air and check that it is clear.
301755-10
–
Remove screw plug
–
Remove pressure spring
301672-10
–
Remove the oil pressure regulator valve. (
–
Measure the spring length of the oil pressure regulator valve.
Oil pressure regulator valve
Minimum length of pressure spring
» If the measured value does not meet specifications:
–
Change the spring.
–
Install the oil pressure regulator valve. (
200155-10
of the crankshaft.

all the way, with the open side facing inward.

p. 225)
with sealing washer .
 
and ball .
 
p. 123)
38.5 mm (1.516 in)
p. 124)
123