Removing The Oil Filter - KTM 525 XC ATV 2008 Owner's Manual

MAINTENANCE ON CHASSIS AND ENGINE
x

Removing the oil filter

Warning
Danger of scalding Engine oil and gear oil get very hot when the vehicle is driven.
Wear suitable protective clothing and gloves. If you scald yourself, hold the affected area under cold water immediately.
Warning
Environmental hazard Problem materials cause environmental damage.
Dispose of oil, grease, filters, fuel, cleaning substances, brake fluid, batteries, etc. according to regulations.
Remove the plug screw
Completely drain the engine oil.
600136-10
Check parts for damage and wear. Replace damaged or worn parts.
Thoroughly clean parts and sealing area.
Oil the O-rings
insert them until the O-ring is seated in the housing
Fit the plug screw
Specification
Locking screw, oil sieve, long
600144-10
Insert the oil screen
Specification
Locking screw, oil sieve,
short
600140-10
Fit oil drain plug
Specification
Oil drain plug with magnet
Install the engine guard. (
600134-11
Place a suitable container under the engine.
and large oil screen with both O-rings.
, mount them on the oil screen
with seal ring and tighten it.
M20x1,5
with the O-rings into the plug screw
M16x1,5
with seal ring and tighten it.
M12x1,5
P. 65)
and using a long hexagon key
with the oil screen.
15 Nm
(11.1 lbf ft)
and tighten.
10 Nm Engine oil (any)
(7.4 lbf ft)
20 Nm
(14.8 lbf ft)
74