Setting The Start Bar "Auto Hide" Property/Changing The Screen Resolution - Avaya MERLIN MAGIX Maintenance And Troubleshooting Manual

13. Verify the following settings:
Connection Preferences
Data Bits: 8
Parity: None
Stop Bits: 1
[X] Wait for dial tone before dialing.
Advanced
[X] Use Flow Control
[X] Hardware (RTS/CTS)
14. To save the new settings, click OK.
15. To close the Modem Properties dialog box, click Close.
16. From the Control Panel, click File, then choose Exit to leave the Control Panel and return to the
Windows desktop.
Be sure to always select the new modem from the list presented during connection to
WinSPM.
Setting the Start Bar "Auto Hide" Property/Changing
the Screen Resolution
Some WinSPM screens may be difficult to use in 640x480 resolution because they use the full
height of the screen. For this reason, you must either turn "Auto hide" on for the Taskbar or
increase your screen resolution settings. If you cannot see the OK button at the bottom of the
screen, perform one of the following procedures.
Setting the Start Bar "Auto hide" Property
1. Right click an area of the Taskbar that is not a button. By default, the Taskbar is located at the
bottom of the screen.
2. Select "Properties" from the pop-up menu.
3. On the Taskbar Properties dialog box, make sure that the "Auto hide" check box is selected.
4. Click Apply, then click OK. The Taskbar disappears. To bring up the Taskbar, simply move your
mouse to the edge of the screen where it was previously displayed.
5. You should now be able to see the OK button. Simply click it to continue your first-time
execution of WinSPM.
About WinSPM
3
3
Setting Up your Desktop
3-7