Extension Forced Idle; Forced Idle Reminder Tone; 100Dcd, Or 100R Ina Module Idle - Avaya MERLIN MAGIX Maintenance And Troubleshooting Manual

System Programming Basics

Extension Forced Idle

When an extension is forced idle, no calls can be made or received on that extension. The
following procedures can be performed only when the extension being programmed is idle:
Assign call restrictions
I
Assign pool dial-out restrictions
I
Copy extension assignments
I
Assign lines, trunks, or pools to extensions
I
Assign labels to a personal directory
I
Use centralized telephone programming
I
When the extension is forced idle, the following occurs: multiline telephone users hear a reminder
tone that indicates the telephone cannot be used; display telephone users see the message
Wait: System Busy ; single-line telephone users do not hear a dial tone.

Forced Idle Reminder Tone

The forced idle reminder tone is a high-low "door-telephone" tone → 400 ms of 667 Hz tone
followed by 400 ms of 571 Hz tone. The tone is provided under the following circumstances:
At the extension, to remind the user that the system or the extension is in the forced idle state.
I
At the programming console or at a PC running WinSPM, to remind the System Manager that
I
the system (or at least one extension) is in the forced idle state because of administrative
activity.
Forced idle reminder tones occur every 20 seconds. You can adjust the volume of these tones with
the volume control on the system console or PC.
100D, 100DCD, or 100R INA Module Idle
The following procedures can be performed only when the 100D, 100DCD, or 100R INA module is
idle:
Specify board type
I
Specify frame format
I
Specify board signaling format
I
Specify board suppression format
I
Specify board facility compensation
I
About Programming and Idle States
1-6
1
1
1