Avaya MERLIN MAGIX Maintenance And Troubleshooting Manual page 102

Select Exit .
7. The current module and version is shown on the screen, followed by Select one: and the
available versions for upgrade of this module.
8. Select the version desired (you may have only one choice). The selection is highlighted.
9. Press Enter, and select Yes when Do you want to continue? is displayed.
10. In Progress and the percentage completed is displayed as the upgrade is loaded.
11. When the upgrade is complete, the following appears:
Upgrade Successfully Completed.
Slot Busied Out.
Slot Restore Needed.
12. Select Exit , and select Restore from the Maintenance menu, then select Yes when Do you
want to continue? is displayed.
13. Repeat steps 3 through 12 above for each module to be upgraded.
When Upgrade(s) are completed, verify the application version of the each module by selecting in
Maintenance > System > Inventory , to assure the proper version.
Table 4-4. Error Conditions During Firmware Upgrade
Error Messages
Memory card is in use by another
feature
Verify that Memory Card has been
inserted correctly
Information on the Memory Card is
corrupted. Please remove the
Memory Card.
Module can not be upgraded.
Module error
Corrective Action
Select Exit and try again.
Insert the memory card correctly; then select
Exit and begin the upgrade procedure again.
Select Exit . Remove the memory card and
repeat the upgrade procedure with a new
memory card.
This procedure can be run only on the 800
GS/LS-ID, 016 (T/R), or 800 NI-BRI modules
or other modules Select Exit and repeat the
upgrade procedure, being careful to select the
correct slot. If upgrade canceled
upgrade incomplete appears on the error
screen, circuit module may be unreliable or
the
unusable until a successful upgrade is
performed on it.
Select Exit and begin the upgrade procedure
again.
Control Unit Problems
or
Module Problems
4-21