About Alarms; Clearing Alarms - Avaya MERLIN MAGIX Maintenance And Troubleshooting Manual
Integrated system release 2.0 and earlier
Hide thumbs
Also See for MERLIN MAGIX:
- Release note (24 pages) ,
- System programming (2 pages) ,
- Configuration note (12 pages)
Table of Contents
Advertisement
Maintenance and Troubleshooting
About Alarms
If the automatic tests indicate serious error conditions, the system generates an alarm. Depending
on how the system is programmed, the system announces an alarm condition in one of the
following ways:
An LED for a line or feature button turns on at an operator console or other designated
I
telephone.
The red status LED on the processor module lights.
I
The error code/status display on the processor module displays F if a frigid start, or C if a cold
I
start, occurs. See
If a software installation or upgrade is taking place, a blinking character is displayed to indicate
I
the status of the procedure. See "PCMCIA Upgrade Card" in Installation for more information.
The status display indicates an alarm (on a 4424LD+ or MLX-20L console or on a PC running
I
WinSPM) and can be viewed on the Error screen.
A supplemental alert, bell, chime, or strobe, if installed, is activated.
I
If an LED is programmed to indicate the alarm, the LED stays lit until the error is cleared.
I
When the system indicates an alarm, check the permanent error log.
I
Clearing Alarms
The system clears alarms automatically when the error condition no longer exists.
To clear an alarm manually, select Drop on the 4424LD+ or MLX-20L programming console. If you
are using WinSPM in Standard SPM Mode on a PC, select Drop on the emulation display of the
programming console. See
There is no fixed Drop button on the 4424LD+ console. The Drop button must be
programmed onto a fixed feature key.
About Alarms
1-8
''About System Restarts''
''Error Logs''
on page
1
on page
1-9
for more information.
1
2-1
for more information.
Advertisement
Chapters
Table of Contents
Troubleshooting
