Restore - Avaya MERLIN MAGIX Maintenance And Troubleshooting Manual

Restore

Use this procedure to restore system conditions that were backed up onto a translation memory
card. The information in a backup file on the translation card is copied to the system.
The restore procedure is necessary under the following conditions:
System RAM is corrupt.
I
A previously stored set of system conditions is preferred over the current set.
I
The processor module is replaced.
I
After a System Erase (frigid start) has been performed.
I
The system software has been reinstalled.
I
The Inspect feature is available to view the attributes of the backup files on the memory card prior
to initiating the restore procedure. The attributes included on the Inspect screen are the filename,
the time and day of the file backup/update, the location of the system programming port, and
information about the system software release from which the backup was made.
If any type of programming is taking place at another extension when you begin the restore
procedure, the restore is canceled and the number of the busy extension appears on the screen.
Repeat the restore procedure when the busy extension becomes idle.
If a line is busy (incoming call or active call) when you begin the restore procedure, the restore is
canceled and the number of the active line appears on the screen. Repeat the restore procedure
when the line becomes idle.
Procedure
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
Copy Option
→
Insert memory card
→
Select the restore file
System Manager
All
System Forced Idle
Not applicable
Not applicable
Not applicable
Yes
No
Backing Up with a Memory Card
6
→
System Back/Restore
Yes
→ →
Restore
Restore
B-7