Avaya MERLIN MAGIX Maintenance And Troubleshooting Manual page 365

If you have multiple modems installed in your system, after clicking OK, you may be
I
prompted to select the modem you want to connect with.
Clicking CANCEL from the Connection Selection screen causes you to return to
I
either the Main screen or the First-Time User Wizard, depending on from where the
screen was started.
Manual Connection
To set up a site for a Manual Connection, do the following:
1. Using the instructions packaged with your PC modem, verify that the software and hardware
flow control is disabled in the modem properties. This is required when connecting to a
MERLIN MAGIX Release 1.5 or later system, and is recommended for all releases of the
communications system.
2. From the Site Setup screen, click Add. The cursor moves to the Site Name field.
3. Type in the Site Name you wish to use and press the Tab key. Site Names are limited to 30
characters. You may use only characters that are acceptable for filenames in the Windows
environment.
4. Complete the following fields to help you differentiate this site from any other site(s) that you
may want to add. These fields are not required; therefore, you may fill in as many or as few as
you determine necessary:
– Address
– City
– State
– Postal Code
– Country
– Contact
– Telephone
– Notes
5. Click the Manual Connectiontab.
6. Click the Enabled check box. A check mark appears in the box and the Dial String dialog box is
no longer grayed out.
7. If you want to add another site, click Add and begin on Step 2 in the process for the
appropriate connection type for the next site.
8. When you finish adding sites, click Apply.
When using Manual to connect, a dialog box with an OK button appears. When you see this box,
place a voice call to the system on a regular line and ask the operator to transfer you to the
MERLIN MAGIX programming port by dialing *10. When you hear the modem answer tone, click
OK to complete the connection and then hang up the handset.
About WinSPM
3
Setting Up a Site
3-13