Frigid Start (System Erase) - Avaya MERLIN MAGIX Maintenance And Troubleshooting Manual

Maintenance and Troubleshooting
A cold start is performed to refresh the Message Waiting Lights on a local system and on all
I
remote MERLIN MAGIX systems that use the local system's Voice Messaging System. If, after
a cold start, any Message Waiting Lights on any of the systems are not refreshed, perform a
manual update. See

Frigid Start (System Erase)

CAUTION:
All system programming is erased. When you perform a frigid start (System Erase), all
I
calls are dropped, and the system configuration information is erased. All system memory
must be reinitialized, including system programming. Then the entire system must be
rebooted.
Do not perform a Frigid Start unless you are installing a replacement processor or
I
following instructions from your TSO.
Procedure
To perform a Frigid Start (System Erase) from the programming console or from WinSPM in
Standard SPM mode, select:
→
Menu
Maintenance
5 of the display, left button)
Considerations
System Erase is not displayed on the 4424LD+ or MLX-20L status display to prevent
I
processor memory from being accidentally changed. To select System Erase , press the left
button on Line 5 of the display twice.
After a System Erase, the default printer is the PC printer, not the Station Message Detail
I
Recording (SMDR) printer. If you want onsite printouts from the SMDR printer, make sure you
change the option. See "Print Opts" in Programming Basics for the procedure to change the
printer option.
About System Restarts
1-10
''Centralized Voice Messaging''
→ → →
Dial 00
Slot
→
System Erase (Line 5 of the display, left button)
on page 1-11
1
1
→
Enter Demand Test
1
for more information.
→
System Erase (Line
→
Yes