Maintenance and Troubleshooting
Restore
Once you complete module testing, restore it to terminate the Busy-Out or Reset condition.
Procedure
Appropriate Modules
Time Estimate
Busy-Out and Reset
6-6
→
Menu
Maintenance
→
→
Enter
Restore
Yes
While the module is restoring service to the lines/trunks and
extensions, a Restore in Progress message is shown on the
screen. When the module is successfully restored, Restore
Complete is displayed. If the restore fails, Restore FAILED
Board Mismatch is displayed. In this case, try the restore again
and be sure you specified the correct slot.
Any module after testing it.
In the procedure above, when you select Enter , the following
additional options appear, depending on the module:
For all MLX modules,
I
For 100D modules, CSU-lpbk , Error Events , and Clock
I
are also displayed.
For all 800 NI-BRI modules, Clock , BChLoopback , and
I
Provisioning are also displayed.
Less than 1 second.
When the 100R INA and 100 DCD modules are restored, router
service is restored at the module level.
6
→
→
Enter the slot no. (01-17)
Slot
is also displayed.
BChLoopback
→