H3: Analog Inputs - Omron Q2V Series Technical Manual

12.7 H: TERMINALS
■
69: ModbusReg 2
Setting Value Function
69 ModbusReg 2
■
6A: DataLog Error
Setting Value Function
6A DataLog Error
■
90 to 92: Q2pack DO1 to 3
Setting Value Function
90 - 92 Q2pack DO1 to 3
■
100 to 192: Inverse output of 0 to 92
Setting Value Function
100 - 192 Inverse output of 0 to 92
For example, set H2-xx = 103 for the inverse output of 3 [Fault].
◆

H3: ANALOG INPUTS

WARNING! Sudden Movement Hazard. Do test runs and examine the drive to make sure that the command references are
correct. If you set the command reference incorrectly, it can cause damage to the drive or serious injury or death.
Drives have two analog input terminals: terminals AI1 and AI2. Use H3 parameters to set the functions to these
analog input terminals and adjust signal levels.
This table shows the functions that you can set to analog input terminals. Use H3-02 and H3-10 [MFAI Function
Select] to set functions.
Setting
Value
0 Through Mode
1 AuxFreqRef1
2 AuxFreqRef2
3 FrqBIAS Frq
4 Freq Ref/BIAS
5 Freq Gain
6 OutVolt Bias
7 TorqCompensation
8 TorqRef/Lim
9 FW Trq Lim
B Rev Trq Lim
C RegenTrqLim
Note:
All analog input scaling uses gain and bias for adjustment. Set the gain and bias values correctly.
608
V/f OLV OLV/PM OLV/PM AOLV/PM EZOLV
The terminal activates when the bit specified by H2-10 [Mbus Reg2 Bit Select] for the Modbus register address set with H2-09
[Mbus Reg2 Address Select] activates.
V/f OLV OLV/PM AOLV/PM EZOLV OLV/PM
The terminal activates when the drive detects LoG [Com Error / Abnormal SD card].
V/f OLV OLV/PM AOLV/PM EZOLV OLV/PM
Sets the Q2pack digital output. Refer to the Q2pack online manual for more information.
V/f OLV OLV/PM AOLV/PM EZOLV OLV/PM
Causes inverse output of the function for the selected MFDO. Uses the last two digits of 1xx to select which function to
inversely output.
Table 12.47 MFAI Setting Values
Function
Description
Description
Description
Description
Setting
Reference
Value
613 D GenerTrqLim
613 E OvUntrq Level
613 F PID Fbk
613 10 PID SetPoint
613 11 Diff PIDFbk
614 12 AcDcTimeGain
614 13 DCInjBrakCurr
614 14 StallPLev@Rn
614 15 OutFLowLimSel
614 16 Mot PTC Input
616 30 Q2pack AI1
616 31 Q2pack AI2
Function
SIEPCYEUOQ2V01A Q2V Technical Manual
Reference
616
616
616
616
616
617
617
617
618
618
618
618