Warning Label Content And Location - Omron Q2V Series Technical Manual

i.1 Safety Information
Use an inverter-duty motor or vector-duty motor with reinforced insulation and windings
applicable for use with an AC drive.
If the motor does not have the correct insulation, it can cause a short circuit or ground fault from insulation
deterioration.
When you touch the drive and circuit boards, make sure that you observe correct electrostatic
discharge (ESD) procedures.
If you do not follow procedures, it can cause ESD damage to the drive circuitry.
Do not do a withstand voltage test or use a Megger insulation tester on the drive.
These tests can cause damage to the drive.
Do not operate a drive or connected equipment that has damaged or missing parts.
You can cause damage to the drive and connected equipment.
Do not use steam or other disinfectants to fumigate wood for packaging the drive. Use
alternative methods, for example heat treatment, before you package the components.
Gas from wood packaging fumigated with halogen disinfectants, for example fluorine, chlorine, bromine, iodine
or DOP gas (phthalic acid ester), can cause damage to the drive.
◆

Warning Label Content and Location

The drive warning label is in the location shown in
A - Warning label
16
NOTICE
Figure i.1. Use the drive as specified by this information.
Figure i.1 Warning Label Content and Location
SIEPCYEUOQ2V01A Q2V Technical Manual