Led Flashing Statuses - Omron Q2V Series Technical Manual

4.2 Component Names and Functions
Symbol Name
Left Arrow Key
Up Arrow Key/
Down Arrow Key
/
G
Right Arrow Key
(RESET)
ENTER Key
ESC Key
H
I LED Display
LO/RE Selection
Key
J
REV LED
K
PACK LED
L
M RJ-45 Connector
WARNING! Sudden Movement Hazard. If you change the control source when b1-07 = 2 [LO/RE Run Selection = Accept RUN],
the drive can start suddenly. Before you change the control source, remove all personnel from the area around the drive, motor,
and load. Sudden starts can cause serious injury or death.
◆

LED Flashing Statuses

106
Moves the cursor to the left.
• Moves to a different screen.
• Selects parameter numbers and increments or decrements setting values.
• Moves the cursor to the right.
• Restarts the drive to clear a fault.
• Enters parameter values and settings.
• Selects each mode, parameter, and set value.
• Goes back to the previous screen.
• Push and hold to go back to the frequency reference screen (the initial screen).
Shows parameters, errors, and other data.
Switches drive control for the Run command and frequency reference between the keypad (LOCAL) and an external source
(REMOTE).
Note:
• The LOCAL/REMOTE Selection Key continuously stays enabled after the drive stops in Drive Mode. If the application must not
switch from REMOTE to LOCAL because it will have a negative effect on system performance, set o2-01 = 0 [LO/RE Key
Selection of Function = Disabled] to disable
• The drive will not switch between LOCAL and REMOTE when it is receiving a Run command from an external source.
Illuminated: The drive received a Reverse run command.
Illuminated: The drive is In Q2pack operation.
Connects to the drive. Use an RJ-45 8-pin straight through UTP CAT5e extension cable to install the keypad in a different location
than the drive.
Figure 4.2 About indicator flashing statuses
/
Figure 4.3 Relation between RUN indicator and Drive Operation
Function
.
SIEPCYEUOQ2V01A Q2V Technical Manual