Diagnostic Code Indication - Honda Transalp XL700V Manual

DIAGNOSTIC CODE INDICATION

Remove the under cowl (page 2-13).
Disconnect the CKP sensor 2P (Red) connector.
Connect the inspection adaptor to the wire harness
side connector.
Connect the Red clip of the adaptor to the 12 V bat-
tery positive (+) terminal and Black clip to the nega-
tive (–) terminal.
TOOLS:
Inspection test harness
Test harness adaptor
Turn the ignition switch ON with the properly regis-
tered key.
The HISS indicator will come on for approx. ten sec-
onds then it will start blinking to indicate the diag-
nostic code if the system is abnormal.
The blinking frequency is repeated.
The HISS indicator remains on when the system is
normal. (The system is in the normal mode and the
diagnostic code does not appear.)
DIAGNOSTIC CODE
When the system (ECM) enters the diagnostic mode from the normal mode:
07XMZ-MBW0101
070MZ-MEC0100
BLINKING PATTERN
IMMOBILIZER SYSTEM (HISS)
INSPECTION
TEST HARNESS
12 V BATTERY
SYMPTOM PROBLEM
ECM data is Faulty ECM
abnormal.
Code signals Faulty immobi-
cannot send or lizer receiver or
receive. wire harness
Identification Jamming by the
code is dis- other transpon-
agree. der.
Secret code is
disagree.
2P (RED)
CONNECTOR
TEST HARNESS ADAPTOR
HISS INDICATOR
PROCEDURE
Replace the ECM.
Follow the
troubleshooting
(page 21-9).
Keep the other
vehicle's transpon-
der key away from
the immobilizer
receiver more than
50 mm (2.0 in).
21-7