Set Interface Ppp Command - Avaya P333T User Manual

Chapter 6 Cajun Campus CLI – Layer 2

Set interface ppp Command

Use the set interface ppp command to configure the Avaya P330 PPP interface IP
parameters, exit modem mode, disconnect the PPP session, or reset the connected
modem.
A PPP connection can be established only after the Avaya P330 is configured with
an IP address and net-mask. The IP address is a dummy address that is shared
between two peers, and must be taken from a subnet that is different from the
agent's IP sub-net.
The syntax for this command is:
set interface ppp <ip_addr><net-mask>
ip_addr
net-mask
Example:
Cajun_P330-N> set interface ppp 149.49.34.125 255.255.255.0
Interface ppp has its ip address set
Use the set interface ppp command to enter modem mode, enter terminal mode,
disconnect the PPP session or to reset the connected modem.
The syntax for this command is:
set interface ppp {enable|enable-on|disable|off|reset}
enable
enable-on
disable
off
reset
Example:
Cajun_P330-N> set interface ppp reset
PPP has reset the connected modem.
84
IP address used by the Avaya P330 to connect via its PPP
interface
Subnet mask used by the Avaya P330 to connect via its PPP
interface
Enable PPP and enter modem mode.
Reserved for Avaya Technician use only.
Disable PPP and enter terminal mode
Disconnect the active PPP session.
Reset the connected modem.
Avaya P333T User's Guide