Set Interface Command; Set Interface Ppp Command - Avaya P333R-LB User Manual

Note: If you wish to define a name which includes spaces, you must enclose the
entire name in quotation marks, e.g. "new york".

Set interface Command

Use the set interface command to configure the management interface on the
Master agent of the stack.
The syntax for this command is:
set interface inband <vlan> <ip_addr> <netmask>
inband
vlan
ip_addr
netmask
Example:
P330-N# set interface inband 1 192.168.42.252 255.255.255.0
Interface inband IP address set.
You must reset the device in order for the change to take effect.

Set interface ppp Command

Use the set interface ppp command to configure the Avaya P330 PPP interface IP
parameters, exit modem mode, disconnect the PPP session, or reset the connected
modem.
A PPP connection can be established only after the Avaya P330 is configured with
an IP address and net-mask. The IP address is a dummy address that is shared
between two peers, and must be taken from a subnet that is different from the
agent's IP sub-net.
Avaya P333R-LB User's Guide
Interface name used for the management
The number of the VLAN to be used for management
IP address used for managing the stack
Subnet mask of the management interface
Chapter 5 Cajun Campus CLI – Layer 2
101