Chapter 7 Cli – Layer 3; Router Configuration Contexts - Avaya P334T-ML User Manual

Chapter 7
CLI – Layer 3
This chapter provides all the Layer 3 CLI commands, parameters and their default
values. Not all groups, parameters and commands are available when the P330
boots up from its INIT software.
Before you attempt to access Layer 3 CLI commands, review the Obtaining and
Activating a License Key procedures on page 43, and P330 Sessions on page 50.

Router Configuration Contexts

At this point you can either use the general P330 commands available from the
Router(configure)# prompt or you can enter one of two router configuration
context modes:
• Router interface context:
This allows you to define parameters individually for each interface. To enter
this context, type interface <interface_name>
The prompt changes to Router>(config-if:<interface_name>)#
• Router protocol context:
This allows you to define parameters for a specific routing protocol (RIP, OSPF,
VRRP, and SRRP). To enter this context, type router <protocol_name>
The prompt changes to Router>(configure router:protocol_name)#
To exit these context modes, type the command exit.
P334T-ML User's Guide 149