Set Time Client; Set Ip Route - Avaya P334T-ML User Manual

Chapter 6 CLI – Layer 2
The syntax for this command is:
set time server <ip address>
ip address

set time client

The set time client command is used to enable or disable the periodic
network time acquisition by the switch from the network time server (SNTP or
TIME protocol).
The syntax for this command is:
set time client <enable|disable>

set ip route

Use the set ip route command to add IP addresses to the IP routing table. You
can configure from one to ten (10) default gateways for a P330 stack.
The syntax for this command is:
set ip route <destination> <gateway>
destination
gateway
Output Example:
This example shows how to add a default route to the IP routing table:
P330-N# set ip route
destination = 0.0.0.0
ROUTE NET TABLE
destination
------------------------------------------------------------------------
0.0.0.0
127.1.1.0
------------------------------------------------------------------------
ROUTE HOST TABLE
destination
------------------------------------------------------------------------
127.0.0.1
104
IP address of the TIME server.
IP address of the network, or specific host to be added
IP address of the router
0.0.0.0 192.168.1.1
gateway = 192.168.1.1
gateway flags
192.168.1.1 1
127.1.1.1 1
gateway flags
127.0.0.1 5
Refcnt Use
1 3199
8 7606
Refcnt Use
2 131
Avaya P334T-ML User's Guide
Interface
se0
se1
Interface
lo0