Ip Source-Route - Dell S6100 Configuration Manual

ip source-route

Enable Dell Networking OS to forward IP packets with source route information in the header.
Syntax ip source-route
To drop packets with source route information, use the no ip route-source command.
Defaults Enabled.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.2(1.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.7.0
8.1.1.0
7.6.1.0
7.5.1.0
pre-6.1.1.0
ip tcp initial-time
Define the wait duration in seconds for the TCP connection to be established. This command is supported on the , , , and platforms.
Syntax ip tcp initial-time <8-75>
To restore the default behavior, which causes the wait period to be set as 8 seconds, use the no ip tcp
initial-time command.
776 IPv4 Routing
Description
Introduced on the S6100–ON.
Introduced on the Z9100–ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.