Virtual Lan (Vlan) Commands - Dell S6100 Configuration Manual

•
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.5.1.0
8.3.7.0
8.3.1.0
7.7.1.0
7.5.1.0
6.5.1.0
Example

Virtual LAN (VLAN) Commands

The following commands configure and monitor virtual LANs (VLANs). VLANs are a virtual interface and use many of the same commands
as physical interfaces.
You can configure an IP address and Layer 3 protocols on a VLAN called Inter-VLAN routing. FTP, TFTP, ACLs and SNMP are not
supported on a VLAN.
Occasionally, while sending broadcast traffic over multiple Layer 3 VLANs, the VRRP state of a VLAN interface may continually switch
between Master and Backup.
NOTE: For more information, refer to
chapter.
default vlan-id
Specify a VLAN as the Default VLAN.
Syntax default vlan-id vlan-id
EXEC Privilege
Description
Introduced on the S6100–ON.
Introduced on the Z9100–ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000-ON.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Added support for 4-port 40G line cards on E-Series.
Introduced on the S4810.
Added the vlan option on the E-Series.
Introduced on the C-Series.
Added support for the violate-action and detail options.
Added support for Port Channel.
VLAN Stacking and VLAN-related commands, such as portmode hybrid in the Interfaces
Layer 2 933