BULLETIN NUMBER:
APPLICABLE MODEL:
GESTETNER – DSC332/DSC338/DSC328
LANIER – LD232C/238C
RICOH – AFICIO 2232C/2238C/2228C
SAVIN – C3224/C3828/C2820
SUBJECT: SC397/SC388
SYMPTOM:
SC387/SC388 may occur when you install the machine.
CAUSE:
The drum plate can bend if development unit K (Y) is not set correctly. This will not let development unit C
(M) get set correctly. At this time, development unit C (M) cannot mesh with the mainframe drive gear. As a
result, the development unit cannot be driven when the main switch is turned on.
Action required when installing the machine
NOTE:
Do these steps before you turn on the main
switch.
1.
Turn the transfer belt release lever
counterclockwise.
2.
Loosen two screws that fasten the drum plate.
Then lift the plate until you hear a click.
Copyright 2004 RICOH Corporation. All rights reserved.
TECHNICAL SERVICE BULLETIN
B147/B149/B190 – 012
LD228C
/
10/20/2004
Page 1 of 2