Snmp-Server Host - Cisco Catalyst 3550 Command Reference Manual

Chapter 2 Cisco IOS Commands

snmp-server host

Use the snmp-server host global configuration command to specify the recipient (host) of a Simple
Network Management Protocol (SNMP) notification operation. Use the no form of this command to
remove the specified host.
Syntax Description host-addr
informs | traps
version 1 | 2c | 3
community-string
bgp
bridge
cluster
config
copy-config
entity
envmon
78-11195-09
snmp-server host host-addr [informs | traps] [version {1 | 2c | 3 [auth | noauth | priv]}]
community-string [bgp] [bridge] [cluster] [config] [copy-config] [entity] [envmon] [flash]
[hsrp] [mac-notification] [port-security] [rtr] [snmp] [stpx] [syslog] [tty] [udp-port]
[vlan-membership] [vlancreate] [vlandelete] [vtp]
no snmp-server host host-addr [informs | traps] [version {1 | 2c | 3 [auth | noauth | priv]}]
community-string
Name or Internet address of the host (the targeted recipient).
(Optional) Send SNMP traps or informs to this host.
(Optional) Version of the Simple Network Management Protocol (SNMP)
used to send the traps.
These keywords are supported:
1—SNMPv1. This option is not available with informs.
2c—SNMPv2C.
3—SNMPv3. These optional keywords can follow the version 3 keyword:
•
•
•
Note
Password-like community string sent with the notification operation. Though
you can set this string by using the snmp-server host command, we
recommend that you define this string by using the snmp-server community
global configuration command before using the snmp-server host
command.
(Optional) Send Border Gateway Protocol (BGP) state change traps.
Note
(Optional) Send SNMP Spanning Tree Protocol (STP) bridge MIB traps.
(Optional) Send cluster member status traps.
(Optional) Send SNMP configuration traps.
(Optional) Send SNMP copy configuration traps.
(Optional) Send SNMP entity traps.
(Optional) Send environmental monitor (EnvMon) traps.
auth (Optional). Enables Message Digest 5 (MD5) and Secure Hash
Algorithm (SHA) packet authentication.
noauth (Default). The noAuthNoPriv security level. This is the default
if the [auth | noauth | priv] keyword choice is not specified.
priv (Optional). Enables Data Encryption Standard (DES) packet
encryption (also called privacy).
The priv keyword is available only when the cryptographic
(encrypted) software image is installed.
This keyword is available only when the enhanced multilayer image
is installed.
Catalyst 3550 Multilayer Switch Command Reference
snmp-server host
2-397