Table of Contents
Advertisement
Quality of Service (QoS) Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
47.36 qos statistics policer
Use the qos statistics policer Interface (Ethernet, Port Channel) Configuration
mode mode command to enable counting in-profile and out-of-profile. Use the no
form of this command to disable counting.
This command is relevant only when policers are defined.
Syntax
qos statistics policer
no qos statistics policer
Parameters
•
policy-map-name—Specifies the policy map name. (Length: 1–32
characters)
•
class-map-name—Specifies the class map name. (Length: 1–32 characters)
Default Configuration
Counting in-profile and out-of-profile is disabled.
Command Mode
Interface (Ethernet, Port Channel) Configuration mode
Example
The following example enables counting in-profile and out-of-profile on the
interface.
switchxxxxxx(config)#
switchxxxxxx(config-if)# qos statistics policer
47.37 qos statistics aggregate-policer
Use the qos statistics aggregate-policer Global Configuration mode command to
enable counting in-profile and out-of-profile. Use the no form of this command to
disable counting.
policy-map-name class-map-name
policy-map-name class-map-name
interface
gi1
1
policy1 class1
47
960
Advertisement
Table of Contents
