Fax Signal Method - Xerox ApeosPort-II 5010 User Manual

4 Fax

Fax Signal Method

1
Select an address number or group dial number to which a relay broadcast is
registered and press the <Start> button.
To perform Multiple Relay Broadcast, repeat this step.
DTMF Method
There are two methods in the DTMF method: Auto Send and Manual Send.
Auto Send (transmitting without picking up the receiver)
1
Select [Keyboard] to display the keyboard on the touch screen and enter in the
following format.
2
Select [Next Recipient] to perform Multiple Relay Broadcast.
Note
Password
A pre-registered two-digit number
Note
4
Relay station ID
The last two digits of the initiating station address number registered at the relay
station
Address number
An address number for the relay recipients registered at the relay station
The wildcard "∗" can also be used.
Note
3
Press the <Start> button.
Manual Send (transmitting with picking up the receiver or on-hook)
1
Select the [Advanced Features] tab
to display the [Advanced Features]
screen.
2
Select [On-hook (Manual Send/
Receive)].
3
Select [Manual Send] from the
drop-down menu.
4
Use the keyboard shown in the
touch screen to enter numbers in
the following format.
160
• You can specify up to 20 locations for relay recipients.
• By default, no password is set. For setting a password, contact our Customer Support
Center. If a password has not been set, you do not need to enter one.
• The above dialing format can be registered in an address number to send using the address
number. For information on how to register address numbers, refer to "Address Book"
(P.328).