Xerox ApeosPort-II 5010 User Manual page 491

Category
Error Code
C P F S M O
033-722
O
033-724
O
033-725
O
033-726
O
033-727
O
033-728 O
033-730 O
033-731
O
033-733
O
033-734
O
033-735
O
033-736
O
033-737
O
* If the error persists after following the listed solution, contact our Customer Support Center. The contact number is
printed on the label or card attached on the machine.
Cause and Remedy
[Cause] The document is jammed, or the document pages are over
the limit.
[Remedy] Remove the jammed paper or reduce the document
pages, and retry sending.
[Cause] The reception was interrupted because the image volume
exceeded the upper limit.
[Remedy] Attach a HDD Extension Kit or Extension System Memory
(256MB) to increase the maximum volume of image data.
[Cause] The hard disk is full.
[Remedy] Remove unnecessary data from the hard disk to increase
free disk space.
[Cause] The received document was printed with the single sided
printing, because the 2-sided printing is not available for a
mixed sized document.
[Remedy] No operation is necessary.
[Cause] The received page was printed without being rotated,
because its data volume was too large to change the
orientation automatically.
[Remedy] No operation is necessary.
[Cause] The Auto Print formatting of the received fax document
was interrupted by a manual print operation.
[Remedy] No operation is necessary. The machine will automatically
start the Auto Print job after manual printing.
[Cause] An error occurred during fax communication.
[Remedy] Power-cycle the machine. If the problem persists, contact
our Customer Support Center.
[Cause] The print job for the received fax document was
interrupted.
[Remedy] The Auto Print processing of the received fax document
was interrupted by a manual print operation. No operation
is necessary.
[Cause] An error occurred during fax transmission.
[Remedy] Turn the machine off and on. If the machine conditions are
not improved by performing the relevant remedy, contact
our Customer Support Center.
[Cause] The print job of the received fax document was interrupted
by a report job.
[Remedy] No operation is necessary.
[Cause] An error occurred during fax transmission.
[Remedy] Turn the machine off and on. If the machine conditions are
not improved by performing the relevant remedy, contact
our Customer Support Center.
[Cause] The forwarding job was interrupted because the data
volume exceeded the upper limit.
[Remedy] No operation is necessary.
[Cause] An error occurred during fax transmission.
[Remedy] Try again.
Error Code
15
489