Xerox ApeosPort-II 5010 User Manual page 580

16 Appendix
Supplementary Notes
To activate scaling, turn the scaling setting to ON on the operation panel. If it is OFF, it
is plotted at the same scale (100%).
If the Document Size is Auto and the Scaling Mode is Paper Size
The hard clip setting is inactive. The hard clip area is always the paper's hard clip area.
If the document size = paper size, it plots at the same scale (100%).
If the document size > paper size, it plots at a reduced scale.
If the document size < paper size, it plots at the same scale (100%).
If the origin position for the plotting position is Layout, the document is laid out in the
center. If the origin position is bottom left or center, the origin of the document and the
paper are aligned.
If the Document Size is Auto and the Scaling Mode is ACA
The hard clip setting is inactive. The hard clip area is always the advanced hard clip
area.
16
The scaling factor is determined according to the ACA and the paper size. The range
for the ACA for each paper size is as follows:
The maximum scaling factor is 210% of the advanced hard clip area for each paper size
and the minimum scaling factor is 22.5%.
7. Restrictions When Plotting under Auto Layout
If the Printer is Equipped with Hard Disk(s)
When Auto Layout is used, print data is stored on the hard disk.
578
A3
A0 35
A1 50
A2 71
A3 100
A4 100
A5 100
0 Degrees
Paper
Min Value
Size
P2x - P1x P2y - P1y
A3 7829 5485
A4 5485 3828
A5 3828 2648
B4 6762 4723
B5 4723 3297
A4 A5
25 100
35 25
50 35
71 50
100 71
100 100
Max Value Min Value
P2x - P1x P2y - P1y P2x - P1x
73075 51200 5485
51200 35733 3828
35733 24720 2648
63120 44088 4723
44088 30773 3297
B4 B5
31 100
43 31
61 43
87 61
100 87
100 100
Unit: %
90 Degrees
Max Value
P2y - P1y P2x - P1x P2y - P1y
7829 51200 73075
5485 35733 51200
3828 44088 35733
6762 44088 63120
4723 30773 44088
Unit: Plotter Unit