Xerox ApeosPort-II 5010 User Manual page 455

Category
Error Code
C P F S M O
003-753
003-756
O
003-757
003-760 O O
003-761
O O
003-764
O
003-780
O
003-795
O
003-970
O
005-275
005-280
005-283
005-284
005-285
005-286
012-241
012-242
012-244
012-246
* If the error persists after following the listed solution, contact our Customer Support Center. The contact number is
printed on the label or card attached on the machine.
O [Cause] The selected resolution was too high for scanning mixed
size documents using the 2-sided feature.
[Remedy] Set [Scan Resolution] to [200dpi], and try again.
[Cause] The fax document is all blank.
[Remedy] Check whether or not the document is blank or the
document is correctly loaded.
O [Cause] The mixed sized document was to be scanned with high
resolution using the 2-sided feature.
[Remedy] Set [Scan Resolution] to [300dpi] or lower, and try again.
[Cause] An incompatible combination of features are specified as
document scan conditions.
[Remedy] Check the selected options.
[Cause] The paper size of the tray selected for auto tray is different
from the paper size of the tray selected for Auto Repeat.
[Remedy] Change the paper size for the tray, or change the [Paper
Type Priority] settings.
[Cause] The document has only one page even though [Form
Overlay] has been selected.
[Remedy] Load both the form document and the document to be
overlaid.
[Cause] Failed to compress the scanned document.
[Remedy] Reduce the resolution or the ratio for [Reduce/Enlarge] to
decrease the data size, or split the data to send it
separately.
[Cause] When enlarging/reducing a scanned document to the
specified paper size, the reduction/enlargement ratio value
is out of allowed range.
[Remedy] Take one of the following actions:
Manually enter a reduction/enlargement ratio.
Change the paper size.
Refer to 003-976.
O [Cause] An error occurred in the document feeder.
[Remedy] Turn the machine off and on. Contact our Customer
Support Center.
O [Cause] Finisher malfunction
[Remedy] Turn the machine off and on. If the machine conditions are
not improved by performing the relevant remedy, contact
our Customer Support Center.
O Cause] The Booklet Maker is not fully inserted in the C-Finisher
with Booklet Maker.
[Remedy] Fully insert the Booklet Maker, and turn the machine off
and back on.
Cause and Remedy
Error Code
15
453