Xerox ApeosPort-II 5010 User Manual page 303

Select a position to print from [Top Left], [Top Right], [Bottom Left], and [Bottom Right].
To use the Print User ID feature, the user ID must be set on the print driver
Note •
beforehand. For more information, refer to the print driver's online help.
When user authentication information is not available, "Unknown User" is printed.
•
Banner Sheet
Select whether to output banner sheets to separate different outputs.
A user name and document name are printed on a banner sheet.
Note • Even if the stapler feature is enabled, banner sheets are not stapled.
• On a print job from a Macintosh, the document name does not appear on the banner sheet.
• When printed, banner sheets are counted by meter.
Off
Does not print banner sheets.
Start Sheet
Prints a banner sheet before a print job.
End Sheet
Prints a banner sheet after a print job.
Start Sheet & End Sheet
Prints a banner sheet before and after a print job.
Banner Sheet Tray
Set the paper tray used for banner sheets.
Select from [Tray 1] to [Tray 4].
PostScript Paper Supply
Select whether the PostScript DMS (Deferred Media Selection) feature is enabled or
disabled.
Note • This feature does not appear for some models. An optional package is necessary. For more
information, contact our Customer Support Center.
PostScript Font Absence
Set the action to be taken when a PostScript font specified in a job is not present.
Note • This feature does not appear for some models. An optional package is necessary. For more
information, contact our Customer Support Center.
Cancel Printing
Cancels printing.
Substitute Font and Print
Continues printing, using a substitute font. Courier is used as the substitute font.
PostScript Font Substitution
Set whether to use ATCx as a substitute if a PostScript font specified in a job is not present.
Note • This feature does not appear for some models. An optional package is necessary. For more
information, contact our Customer Support Center.
Print Mode Settings
10
301