Xerox ApeosPort-II 5010 User Manual page 300

10 System Settings
HP-GL/2 Auto Layout Memory
Specify the capacity for HP-GL/2 auto layout memory.
If a hard disk is not installed, data can be stored in the HP-GL/2 auto layout memory. You can
specify a value within the range from 64 to 5,120 KB in 32 KB increments.
Note
Receiving Buffer - Parallel
Set the parallel receiving buffer.
Specify a value from 64 to 1,024 KB in 32 KB increments.
Receiving Buffer - USB
Set the receiving buffer for USB.
You can specify the value within the range from 64 to 1024 KB in 32 KB increments.
Receiving Buffer - LPD Spool
Off
Does not use spooling. While LPD print processing is being carried out for one client, data
cannot be received over the same interface from another client.
Specify a value for the dedicated LPD receiving buffer memory capacity from 1,024 to 2,048
KB, in 32 KB increments.
Memory
Carries out spooling. The receiving buffer for spooling uses memory. When this setting is
selected, specify the memory capacity of a receiving buffer for spooling from 0.50 MB to
32.00 MB, in 0.25 MB increments.
Note that print data exceeding the set memory capacity is not accepted. In such cases, select
[Hard Disk] or [Off].
Hard Disk
Carries out spooling. The receiving buffer for spooling uses the hard disk.
Note
Receiving Buffer - NetWare
Set the NetWare receiving buffer.
Specify a value from 64 to 1,024 KB in 32 KB increments.
Note
Receiving Buffer - SMB Spool
Off
Does not use spooling. While SMB print processing is being carried out for one client, data
10
cannot be received over the same interface from another client.
Specify a value for the dedicated SMB receiving buffer memory capacity from 64 to 1,024 KB
in 32 KB increments.
Important • If you select [Off], job names are displayed as "unknown document name".
Memory
Carries out spooling. The receiving buffer for spooling uses memory. When this setting is
selected, specify the memory capacity of a receiving buffer for spooling from 0.50 to 32.00
MB, in 0.25 MB increments.
Note that print data exceeding the set memory capacity is not accepted. In such cases, select
[Hard Disk] or [Off].
298
• This feature appears when the Adobe PostScript 3 Kit is installed.
• The maximum value that can be set varies according to the available memory capacity.
• This feature does not appear for some models. An optional package is necessary. For more
information, contact our Customer Support Center.
• This feature does not appear for some models. An optional package is necessary. For more
information, contact our Customer Support Center.