Xerox ApeosPort-II 5010 User Manual page 163

Note • You can specify up to 20 locations for relay recipients.
F Code Method
When the machine is an initiating station, you can perform Relay Broadcast by
registering the relay station's F code and password (if necessary) to the machine.
When the machine is a relay station, you can perform Relay Broadcast by registering
the machine's F code and password (if necessary) to an initiating station.
Important • When performing Relay Broadcast with the F Code method, you can use a password if you
Note • When performing Relay Broadcast with machines of this model, we recommend using the
• When using a machine of a different model as a relay station, confirm the F Code (sub-
When using the machine as a relay station, the F Code that is transmitted to the
initiating station is as follows.
Relay Broadcast
Relay Broadcast
The number of digits of the relay station ID:
1: When the relay station IDs and address numbers are two digits
2: When the relay station IDs and address numbers are three digits
Print Directive
Printing/not printing at the relay station
1: Printing at the relay station
0: Not printing at the relay station
Relay Station ID
An address number for an initiating station registered at the relay station
When the relay station ID is set, the initiating station is notified of the results of a Relay
Broadcast.
When the relay station ID is "00" or "000", the initiating station is not notified of the
results of a Relay Broadcast.
Address Number
The address number assigned to the relay recipient
The following shows an example of F Code that indicates printing at the relay station,
notifying the initiating station (100) of the results, and performing Relay Broadcast to
relay recipients (200, 201, 202 and 203).
F Code Example: 21100200201202203
set a receive password for the relay station.
fax signal method.
address) and password of the target recipient machine.
Print Relay
Directive Station ID
Up to 20 digits
Address Address Address
Number Number Number
Broadcast
....
4
161