Xerox ApeosPort-II 5010 User Manual page 412

14 Maintenance
3
Unlock the Cover A by lifting up the
release lever on the upper right of
the Cover A, and then open the
Cover A.
4
Lift up the release lever of the drum
cartridge, and slide the drum
cartridge out until you can lift the
handle on top of the drum
cartridge.
5
Hold the handle and remove the
cartridge from the machine.
14 Important • Be sure to hold the drum
6
Remove the new drum cartridge
from the box.
Important • Do not place the new drum
7
Place the drum cartridge on a flat
surface. Undo the sealing tape as
shown, and carefully pull it out to
remove the protective sheet out of
the cartridge.
Important • Be sure to pull the protective
410
cartridge by its handle when
removing it out of the
machine. If you do not hold it
by its handle, it might fall out
of the machine and soil the
floor.
cartridge in an upright
position.
• Return used drum cartridges
to our Customer Support
Center.
sheet out straight and
horizontally. If it is pulled out
upward, it may tear before it is
completely out of the
cartridge.
• After pulling out the protective sheet, do not shake the drum cartridge or handle it roughly.