Xerox ApeosPort-II 5010 User Manual page 478

15 Problem Solving
Error Code
C P F S M O
024-742
024-746
024-747
024-748
024-775
024-984
O O
15
026-700
026-701
026-702
027-452
027-500
* If the error persists after following the listed solution, contact our Customer Support Center. The contact number is
printed on the label or card attached on the machine.
476
Category
O [Cause]
[Remedy] Change the [Print Options] setting to split the pages
O [Cause]
[Remedy] Check the print data.
O [Cause]
[Remedy] Check the print data, and try to print again.
O [Cause]
[Remedy] Set [Number of Digits] to [Auto Assign] or a value
O Refer to 024-742.
[Cause]
[Remedy] Replace the staple cartridge with a new one.
For information on how to replace the staple cartridge for booklet, refer to
"Replacing the Staple Cartridge for Booklet (When a C-Finisher with
Booklet Maker is Installed)" (P.415).
O [Cause]
[Remedy] Try again. If the problem persists, contact our Customer
O [Cause]
[Remedy] Wait for a while and try again. If the number of queries to
O [Cause]
[Remedy] Wait for a while and try again. If the problem persists,
O [Cause]
[Remedy] Change the IP address.
Refer to the Network Administrator Guide for details.
O O [Cause]
[Remedy] Check on the CentreWare Internet Services if the SMTP
Cause and Remedy
Booklet printing was specified for [Print Options], but the
number of print pages for the job exceeded the maximum
number for booklet creation.
appropriately to create separate volumes, or to cancel the
booklet setting.
The specified paper type is not compatible with the
specified paper size, paper tray, output tray, or 2-sided
printing.
Incompatible print parameters are used. The combination
of the specified features such as Document Size, Paper
Size, Paper Tray, 2 sided print, and Output Tray is
incompatible.
The number of digits specified in [Number of Digits] of the
[Page Number] screen does not match the value specified
in [Start Number] of the [Page Number - Print On] screen.
appropriate for the value specified in [Start Number].
The staple cartridge for booklet is not correctly attached.
By Address Book operation, the machine received an
unsupported protocol from the LDAP server.
Support Center.
The number of queries to Address Book exceeded the
machine's processing capability.
Address Book is only one, the machine's software may be
defective. Contact our Customer Support Center.
The number of access from the LDAP server to the
machine exceeded the machine's processing capability.
contact our Customer Support Center.
The IP address already exists.
Unable to resolve the SMTP server name when returning
e-mail.
server settings are correct.