Xerox ApeosPort-II 5010 User Manual page 161

Fax Signal Method
This method employs a Fuji Xerox proprietary communication procedure that is only for
use with specific machines that have the Relay Broadcast feature. The G3 mode is
available.
DTMF Method
G3 fax machines that support Manual Send can make Relay Broadcast for the
machine.
F Code Method
This method can be used among machines that have the F Code and the Relay
Broadcast features. The G3 is available.
Before using the Relay Broadcast Feature
Before using the Relay Broadcast feature, register the following information in the
address numbers of initiating stations and relay stations.
For information on how to register address numbers, refer to "Address Book" (P.328).
Where
Initiating
Station
Relay
Station
Note • The above describes using Relay Broadcast with the machine. When using a machine of a
* When the Speed Dial Extension Kit is installed, it will be 001 to 999.
Fax Signal Method
Assign the relay station to an address number (001 to 500*) to set up the Relay
Broadcast feature.
Register the last two digits of the address number of the initiating station
(which is already registered at a relay station) as a relay station ID for the
Relay Broadcast operation.
Register the address numbers or group dial number of the relay recipients
(which are registered at a relay station) as broadcast recipients. The wildcard
"∗" can be used.
DTMF Method (G3)/F Code Method
No registration is required. The dialing format can be registered to an address
number.
Fax Signal Method
Assign the initiating station to an address number from 001 to 099 and set
Relay Station Setup of the address number to [On].
Assign the relay recipient to an address number from 001 to 099. The relay
recipients can also be assigned group dial numbers from the initiating station.
DTMF Method (G3)/F Code Method
Assign the initiating station either to an address number from 001 to 500
(when the specification method for the initiating station is 3 digits in F Code)
or to 001 to 099 (when the specification method for the initiating station is 2
digits in F Code). Then, set Relay Station Setup of the address number to
[On].
Assign the relay recipients to an address number.
Assign the relay recipient either to a relay station address number from 001 to
500 (when the specification method for the initiating station is 3 digits in F
Code) or to 001 to 099 (when the specification method for the initiating station
is 2 digits in F Code).
different model as a relay station, obtain the F Code (sub-address) and password of the
target recipient machine.
Contents
Broadcast
4
159