Fax Signal Method - Xerox ApeosPort-III C7600 User Manual

4 Fax

Fax Signal Method

This method employs a Fuji Xerox proprietary communication procedure that is only for
use with specific machines that have the Relay Broadcast feature. The G3 mode is
available.
DTMF Method
G3 fax machines that support Manual Send can make Relay Broadcast for the
machine.
F Code Method
This method can be used among machines that have the F Code and the Relay
Broadcast features. The G3 is available.
Before using the Relay Broadcast Feature
Before using the Relay Broadcast feature, register the following information.
For information on how to register address numbers, refer to "5 Tools" > "Setup" > "Add Address Book
Entry" in the Administrator Guide.
Where
Initiating
4
Station
For the contents to be registered to relay stations, refer to the manual of the relay stations.
Fax Signal Method
1
Select an address number or group dial number to which a relay broadcast is
registered and press the <Start> button.
To perform Multiple Relay Broadcast, repeat this step.
DTMF Method
There are two methods in the DTMF method: Auto Send and Manual Send.
Auto Send (transmitting without picking up the receiver)
1
Select [Keyboard] to display the keyboard on the touch screen and enter in the
following format.
2
Select [+ Add] to perform Multiple Relay Broadcast.
Note
194
Fax Signal Method
Assign the relay station to an address number (0001 to 2000) to set up the
Relay Broadcast feature.
Register the last two digits of the address number of the initiating station
(which is already registered at a relay station) as a relay station ID for the
Relay Broadcast operation.
Register the address numbers or group dial number of the relay recipients
(which are registered at a relay station) as broadcast recipients. The wildcard
"∗" can be used.
DTMF Method (G3)/F Code Method
No registration is required. The dialing format can be registered to an address
number.
• You can specify up to 20 locations for relay recipients.
Contents