Xerox ApeosPort-II 5010 User Manual page 492

15 Problem Solving
Error Code
C P F S M O
033-738
033-740
033-741
033-742
033-743
033-744
033-745
033-746
15
033-747
033-749
033-750
033-755
034-211
034-212
* If the error persists after following the listed solution, contact our Customer Support Center. The contact number is
printed on the label or card attached on the machine.
490
Category
O [Cause]
[Remedy] No operation is necessary.
O [Cause]
[Remedy] No operation is necessary.
O [Cause]
[Remedy] Try again. If the machine conditions are not improved by
O [Cause]
[Remedy] When this error was caused by Manual Send, connect the
O [Cause]
[Remedy] Turn the machine off and on. If the machine conditions are
O [Cause]
[Remedy] No operation is necessary.
O [Cause]
[Remedy] No operation is necessary.
O [Cause]
[Remedy] Turn the machine off and on. If the machine conditions are
O [Cause]
[Remedy] Take one of the following actions:
If the error persists, contact our Customer Support Center.
O [Cause]
[Remedy] Contact our Customer Support Center.
Cause and Remedy
Received abnormal JBIG data.
The print job for the received fax document was
interrupted.
An error occurred during fax transmission.
performing the relevant remedy, contact our Customer
Support Center.
An error occurred during fax transmission. This error may
occur if the remaining capacity of the machine's memory is
10% or less and Manual Send is used.
line after storing the document. If the error is still not
cleared, remove unnecessary data from the hard disk to
increase free disk space, and retry again.
If the machine conditions are not improved by performing
the relevant remedy, contact our Customer Support
Center.
An error occurred during fax transmission.
not improved by performing the relevant remedy, contact
our Customer Support Center.
The job is in pending status.
The machine will automatically resume and print out.
An error occurred during fax transmission.
not improved by performing the relevant remedy, contact
our Customer Support Center.
A fax document was to be printed, but the print job was
canceled because the fax feature did not work.
If multiple documents stored in mailboxes are to be
printed, and one of them is a fax document, the fax
document and the documents to be printed subsequently
will not be printed out.
Turn the machine off and then back on.
Check if the phone cable connection is secured.
Print an Error History Report to obtain the fax-related
error code (133-xxx, 134-xxx), and then solve the
problem.
An error occurred on the fax control system.