Document Glass - Xerox ApeosPort-II 5010 User Manual

1
Remove any paper clips and
staples before loading the
document.
2
Place the document (the front side
of 2-sided document) face up in the
center of the document feeder.
Note • The indicator lights when the
3
Adjust the movable document
guides to just touch the edges of
the document loaded.

Document Glass

The document glass supports a single sheet, a book, or other similar documents up to
297 x 432 mm (A3, 11 x 17 inches).
Important • After using the document glass, close the document cover.
The document glass automatically detects standard size documents. For non-standard
size documents, input the size in the [Original Size] screen.
For information on entering document sizes, refer to "Original Size (Specifying the Scan Size for the
Document)" (P.72).
Note • The standard document sizes that can be detected automatically depend on the [Paper Size
CAUTION
Do not apply excessive force to hold thick document on the platen glass. It may break
the glass and cause injuries.
1
Open the document cover.
Important • Ensure that a screen is
document is loaded correctly.
If the indicator does not light
up, the machine may be trying
to detect a document on the
document glass. Press the
<C> button, and then reload the document.
Settings] in the System Administration mode. For information on the paper size settings,
refer to "Paper Size Settings" (P.280).
displayed on the control
panel, and then load a
document. If a document is
loaded before a screen is
displayed, the machine may
not properly detect the
document size.
Copying Procedure
Indicator
3
55