Audio Tones - Xerox ApeosPort-II 5010 User Manual

Auto Print
Set the time period to start the next print job after finishing a copy operation.
When [On] is selected, specify a value between 1 and 240 seconds, in 1 second increments.
If you select [Off], printing starts immediately after the machine is ready.
Printer Lockout Duration
The machine disables to print received fax documents and reports during a given period of
time.
If you selected [On], specify a starting time and an ending time to disable printing, in 1 minute
increments.
Note • A job which has already been activated before the starting time will be printed continuously
• The print-disabled condition is cancelled when you operate using the control panel after the
• To enable printing during the printer lockout duration, select a job under [Current and
Auto Power Saver
The machine is provided with the Low Power and Sleep modes as the power saving mode.
When a specified period of time has elapsed, the machine switches to these modes in the
following order to reduce power consumption.
Last selection on the machine
For more information, refer to "Changing the Power Saver Mode Change Interval" (P.43).
Note • There is no setting to disable switching to the Low Power mode or the Sleep mode.
From Last Selection to Low Power Mode
Specify a time period between the last operation and entering the Low Power mode in the
range from 2 to 60 minutes, in 1 minute increments.
Note • Configure the [From Last Selection to Sleep Mode] time to be longer than the [From Last
From Last Selection to Sleep Mode
Specify a time period between the last selection and entering the Sleep mode from 2 to 60
minutes, in 1 minute increments.

Audio Tones

Select whether or not to sound an alarm, for example when a job ends or a fault occurs.
Control Panel Select Tone
Select the sound to be made when a button displayed on the screen is correctly selected.
You can select the volume from [Soft], [Normal], and [Loud]. To disable the sound, select
[Off].
Control Panel Alert Tone
Select the sound to be made when an unavailable button is selected, or an error occurs.
You can select the volume from [Soft], [Normal], and [Loud]. To disable the sound, select
[Off].
Machine Ready Tone
Set the sound for when the machine is ready to copy or print, after powering on, for example.
You can select the volume from [Soft], [Normal], and [Loud]. To disable the sound, select
[Off].
Copy Job Complete Tone
even after the starting time elapses.
ending time.
Pending Jobs] on the [Job Status] screen, and then select [Promote Job].
Low Power mode
Selection to Low Power Mode] time.
Common Settings
Sleep mode
10
269