Xerox ApeosPort-II 5010 User Manual page 556

16 Appendix
Setting Item
ESCP switch
16
Position
adjustment
Escape
sequence
554
Item
Number
55 Sets the Text Quality mode to high quality or draft.
(Text quality) [0] (Default)
[1]
Important •Since the [Text Quality], [Reduced Characters], [Character Code
Note •When the setting is changed, only the state of the setting changes,
•This setting affect the Text Quality selection commands.
56 Reduces the size of 1-byte alphanumeric characters when printing. Sets
(Reduced whether to reduce their sizes or to print them in a scale of 100%.
characters) [0] (Default)
[1]
58 Sets the length of a page (printable area) to 11 inches or 12 inches.
(1 Page [0] (Default)
length) [1]
59 Sets whether or not to leave a 1-inch space between pages.
(1-Inch [0] (Default)
perforation skip) [1]
Important •This is only effective when CSF under [Paper Position] is set to [Off].
60 Sets the position to start printing to 8.5 mm or 22 mm below the top edge
(Paper feed of paper.
position) [0] (Default)
[1]
61 Sets the action to be performed when a CR command is received.
(CR feature) [0] (Default)
[1]
15 Adjusts the printing position vertically or horizontally, and changes the
(Vertical positions of the margins.
position [0] (Default)
adjustment) [1-500]
Important •Data outside the printable area will not be printed even when the
16
(Horizontal
position
adjustment)
62
Note •The syntax of an extended command starts with an escape
(Escape
sequence)
[0] (Default)
[1]
63 To control an extended command with a text code, an escape sequence
(Escape (the first two bytes) of the extended command must be specified.
sequence Enter two characters using the keyboard displayed on the screen.
character) (Default: &%)
Value
: High Quality
: Draft
Table], [Page Length], and [1-inch Perforation Skip] features select
the default values, their settings will not be affected when the an
extended command is received.
not the actual printing quality.
: Off
: On
: 11 inches
: 12 inches
: Off
: On
: 8.5 mm
: 22 mm
: Carriage return
: Carriage return and linefeed
: Off
: -250 to +250 mm
printing position is adjusted. In addition, data moved outside the
printable area due to the adjustment of the printing position will not
be printed.
sequence, then the data identifying the command, and followed by
parameters if any. The escape sequence is the first two bytes of an
extended command (an ESC, which is a hexadecimal 1BH, plus the
semicolon (3BH) followed by it). This setting specifies whether or not
to enable the escape sequence you specified. When enabled, an
extended command can be controlled using a text code. The default
setting is "Disabled".
: Disabled
: Enabled