Xerox ApeosPort-II 5010 User Manual page 167

Register the following information in the address numbers of the primary relay station
and the secondary relay station in advance.
Where
Primary Assign the initiating station either to an address number from 001 to 500* (when
Relay the specification method for the initiating station is 3 digits in F Code) or to 001
Station to 099 (when the specification method for the initiating station is 2 digits in F
Code). Then, set Relay Station Setup of the address number to [On].
Assign the secondary relay station either to an address number from 001 to
500* (when the specification method for the initiating station is 3 digits in F
Code) or to 001 to 099 (when the specification method for the initiating station is
2 digits in F Code).
As the relay station ID, assign the last two digits of the Address Number for
the primary relay station that is registered to the secondary relay station.
As the broadcast recipients, assign the Address Number for the relay
recipients that have been registered to the secondary relay station.
Secondary Assign the primary relay station to the same address number as that of the
Relay initiating station registered at the primary relay station, and set Relay Station
Station Setup of the address number to [On].
Assign the relay recipients either to an address number from 001 to 500* (when
the specification method for the initiating station is 3 digits in F Code) or to 001
to 099 (when the specification method for the initiating station is 2 digits in F
Code).
Important • When using the F Code method for Remote Relay Broadcast, the primary relay stations and
secondary relay stations must support our F Code method and be equipped with the Relay
Broadcast feature.
Note • When performing Relay Broadcast with machines of this model, we recommend using the
fax signal method.
* When the Speed Dial Extension Kit is installed, it will be 001 to 999.
When using the machine as a relay station, the F Code that is transmitted to the
initiating station is as follows.
Relay Broadcast Print
Directive
Relay Broadcast
The number of digits of the relay station ID:
1: When the relay station IDs and address numbers are two digits
2: When the relay station IDs and address numbers are three digits
Print Directive
Printing/not printing at the relay station
1: Printing at the primary relay station
0: No printing at the primary relay station
Contents
Primary Address Address
Relay Number Number
Station ID
Up to 20 digits
Broadcast
Address
Number
....
165
4